Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
464224211 • 13
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
CAUTION
CAUTION
SPIDER ALERT!
If you notice that your grill is getting hard to light or that the
flame isn’t as strong as it should be, take the time to check and
clean the See section “Cleaning Burner burner tubes.
Assemblies” next page.
To prevent flashbacks and ensure good performance the burner and
burner tube assembly should be removed from the grill and cleaned
before use whenever the grill has been idle for an extended period.
VALVE
CONTROL PANEL
SPIDER WEBS
INSIDE BURNER TUBE
BURNER
SPIDER AND WEBS
• Turn all knobs to OFF position. Turn LP cylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder. Push and turn control knob to
and hold in. You will hear a clicking sound as the burner is being
ignited. Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
Valve Check
• Important: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn
back to OFF position. Valves should turn smoothly.
Burner Flame Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH to low. You should see a smaller flame in
low position than seen on HIGH Perform burner flame check on
side burner, searing burner and rotisserie also. Always check flame
prior to each use. If only low flame is seen refer to "Sudden drop
or low flame" in the Troubleshooting Section.
HIGH
LOW
Turning Grill Off
INSIDE BURNER TUBE
Do not remove glass for cleaning.
Glass is not dishwasher safe.
Spiders or small insects have been known to create “flashback”
problems. The spiders spin webs, build nests and lay eggs in the
grill’s venturi tube(s) obstructing the flow of gas to the burner.
The backed-up gas can ignite in the burner tube behind the
control panel. This is known as a flashback and it can damage
your grill and even cause injury.
Figure D
Side burner Ignitor Lighting
Do not lean over grill while lighting.
1. Open side burner lid. Turn ON gas at LP cylinder.
2. Turn side burner knob to the HI position, push and hold
ELECTRONIC IGNITOR button.
3. If side burner does NOT light within 5 seconds, turn knob
to repeat lighting procedure.OFF, wait 5 minutes, then
Match lighting the Side Burner - Figure D
1. Open the side burner lid during lighting.
2. Place match in match holder. Strike the Match. Position
lit match close to the side burner.
3. Push in and turn side burner knob to position. Be sure
burner lights and stays lit.
4. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting procedure.