Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Cleaning The BurnerAssembly
Follow these instructions to clean and/or replace parts of bumer
assembly or if you have trouble igniting grill.
1. Turn gas off at control knobs and LP tank,
2. Remove cooking grate and V-bar.
3. Remove grease can from beneath grill. Beneath grill bottom,
disconnect ignitor wire from electrode.
4. Remove screw holding collector box. Notewhich hole on
collector box used for attaching to burner. Remove collector
box and clean ceramic portion of electrode with rubbing
alcohol and cloth.
5. Under control panel,disengage burner springs from burner
tubes. Do not remove springs from valves.
6. To remove burner, slide backwards, lift up and out of grill.
7. Clean outside of burner with soap and water. Lay burner
upside down on fiatsurface. Force a stream of water through
tubes. Make sure water comes out of all burner holes. Open
clogged holes with a thin wire. Shake out excess water and
examine holes. Due to normal wear and corrosion, some
holes may become enlarged. If any largecracks or holes are
found replace burner.
,
If grill is to be stored, coat burner lightlywith cooking oil.
Wrap in protective cover to keep insects out. Ifnot storing grill
after cleaning, hold burner at an angle and insert into grill
bottom.
9. After cleaning, insert electrode into hole in grill bottom.
Reattach collector boxto burner with screw. Be sure to use
correct hole.
10.Place end of spring into hole on underside of burner tube, as
before, to secure burner. See figureA.
VERY IMPORTANT: Burnertube must engage valve opening
as shown in figure A.
11.Reattach ignitorwireto electrode.
12.Reposition V-bar and cooking grate. Reattach clean can to
grease clip.
13.Before cooking again on grill, follow "Burner Flame Check".
• Do notuse charcoalwith this grill.
Collector..-_ '_
Box
Burner
Ignitor
Wire
463845504°23