Kenmore 415.1613911 Gas Grill User Manual


 
SideburnerIgnltor Lighting
Do not lean over grill while lighting.
1. Open sldeburner lld. Turn ON gas at LP cylinder.
2. Turn sideburner knob to the HI position, push and hold
ELECTRONIC IGNITOR button.
3. If sideburner does NOT light within 5 seconds, turn knob
to OFF, wait 5 minutes, then repeat lighting procedure.
Match lighting the Side Burner - Figure D
1. Open the sideburner lid during lighting.
2. Place match in match holder. Strike the Match. Position
lit match close to the side burner.
3. Push in and turn side burner knob to _ position. Be sure
burner lights and stays lit.
4. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes for gas to clear away,
and repeat the lighting procedure.
Burner Flame Check
Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH _ to low. You should see a smaller flame in
low position than seen on HIGH Perform burner flame check on
sideburner, sear burner and rotisserie also. Always check flame
prior to each use. If only low flame is seen refer to "Sudden drop
or low flame" in the Troubleshooting Section.
6' 0 6, 0 _ 0
Turning Grill Off
° Turn all knobs to OFF position. Turn LPcylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
' Turn gas off at LPcylinder. Push and turn control knob to
and hold in. Youwill hear a clicking sound as the burner is being
ignited. Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
Valve Check
Important: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn
back to OFF position. Valves should turn smoothly.
Hose Check
" Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
CAUTION
SPIDER ALERT!
If you notice that your grill isgetting hard to light or that the
flame isn't as strong as it should be, take the time to check ant
clean the burner tubes. See section "Cleaning Burner
Assemblles" next page.
CONTROL PANE L'_-
SPIDER WEBS
/ INSIDE BURNER TUBE
il
BURNER
i
Spiders or small insects have been known to create "flashback"
_roblems. The spiders spin webs, build nests and lay eggs in the
grill's venturi tube(s) obstructing the flow of gas to the burner.
The backed-up gas can ignite in the burner tube behind the
control panel. This is known as a flashback and it can damage
your grill and even cause injury.
To prevent flashbacks and ensure good performance the burner and
burner tube assembly should be removed from the grill and cleaned
before use whenever the grill has been idle for an extended period.
J
CAUTION
Do not remove glass for cleaning.
Glass is not dishwasher safe.
464224211 ° 9