Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Main burner Ignitor Lighting
A Do not lean over grill while lighting.
1. Open lid during lighting.
2. Turn ON valve from source or tank.
3. Push and turn Ignition Burner control knob to _- HI and
immediately press and hold Electronic Ignition button.
4. If ignitiondoes NOT occur in 5 seconds, turn Left Burner
control knob OFF, wait 5 minutes for gas to clear and repeat
the lighting procedure.
5. To Light Other Burners turn control knob to HI.
If ignitordoes not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for 15 minutes to pre-
heat grill. Then turn knob to desired setting for cooking.
CAUTION
If burner does not light, turn knobs to OFF, wait 5
minutes, and try again. Always close valve during the 5
minute waiting period, ifthe burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
Match-Lighting
A Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match intomatch holder (hanging from side of cart).
3. Push in and turn left knobto ,¢ HI position. Be sure burner
lights and stays lit.
4. Light right burner by pushing knob in and turning to_,. HI
position.
Before Your First Cookout
. Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGHfor 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
, Light burner, rotate knobs from HIGH to LOW.You should see
a smaller flame in LOW position than seen on HIGH.Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the TroubleshootingSection.
Hose Check
Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal Kinked
Hose Hose
Sideburner ignitor Lighting
A Donot leanover grill while lighting.
1. Open lid or cover for Side Burner during lighting.
2. Turn ON valve from source or tank.
3. Push and turn Side Burner control knob to¢ HI and
immediately press and hold ElectronicIgnition button.
4. If ignition does NOT occur in 5 seconds, turn Side Burner
control knob OFF, wait 5 minutes for gas to clear, and
repeat the lighting instructions.
If ignitordoesnotwork,followmatchlightinginstructions.
AfterLighting:Turnknobsto HIpositionforwarm-up.
Sideburner Match Lighting
1. Open top cover. Turn on gas at LP tank.
2. Holdlit match to any port on the burner. Push in and turn
sideburner knob to ._¢ HIGH. Be sure burner lights and
stays lit.
8• 464810408