Grizzly T10041 Outdoor Cart User Manual


  Open as PDF
of 4
 
-2-
T10041 Hi-Lift Hydraulic Cart
To assemble the cart:
1. Slide the lifting pedal into the pedal shaft and
secure in place with the M8-1.25 x 20 hex
bolt as shown in Figure 3
.
2. Place the handle in the handle sockets and
secure with the M8-1.25 x 40 hex bolts
(Figure 3).
Assembly
• Lock casters whenever the cart is stationary.
• Balance the load evenly in the center of the
cart.
• Pump the lifting pedal to raise the table.
• Push the pressure release pedal to lower the
table (Figure 3
).
Note: Always lower the table when not in
use.
Operations
• Fully lower the tabletop when not in use.
• Wipe all dirt and dust off the table cart.
• Apply light oil to the surface of the hydraulic
jack ram.
• If the lifting pedal fails to raise the table,
remove the plug on the top of the hydraulic
jack. Add oil until full, replace the plug, then
pump the handle several times with the pres
-
sure release valve open to bleed the air out
of the system.
If you need additional help with this procedure,
call our service department at: (570) 546-9663.
Maintenance
Keep hands away from the
scissor lift to prevent seri
-
ous crushing injuries
.
To reduce the risk of serious personal injury
when using this equipment:
• Keep hands out of the scissor lift to prevent
serious pinching and crushing injuries.
• DO NOT exceed the 330 lb. load capacity.
• Lock the casters when loading and unload-
ing the cart.
• Balance the load evenly in the center of the
cart.
• Transport the load in the fully lowered posi-
tion to prevent tipping.
Figure 3. Assembly.
Lifting Pedal
Handle
M8-1.25 x 20
Hex Bolt
Handle
Hex Bolt
Pressure
Release Pedal
 previous next