Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
BEFORE LIGHTING
Important! Before Lighting...
Check the gas supply line for cuts, wear or abrasion.
Always keep your face and body as far away from the grill
as possible when lighting.
GRILL BURNER LIGHTING
Lighting the Grill with electronic igniter
1. Make sure all control knobs are in the “OFF” position.
2. Open the gas supply valve located on top of your L.P.
tank.
ATTENTION: When turning the L.P. tank on, make sure
to open the valve very SLOWLY two (2) complete turns
to insure proper gas flow.
3. Always open the hood before attempting to light.
4. Push and turn one of the control knobs counter clock-
wise to the “HIGH” position and immediately press the
electronic igniter button. You will hear a snapping sound.
It may be necessary to hold the electronic starter button
for about 4 seconds. (See Fig. 15)
NOTE: If the burner does not light in 4 seconds, turn
the knob to the “OFF” position and wait 5 minutes
before trying again.
5. Repeat above steps to light remaining burners.
Match Lighting
If by chance the electronic igniter does not light the burner,
the burner may be lit with a match. Attach the match to the
match extender, located inside the right cart door.
Keep your face as far away from the grill surface as possible
and pass the match extender through the spaces in the
grill grates to the ports of the back crossover burner
between the flavor grids. Position the match near the burner
ports, then push and turn the control knob counter clockwise
to the “HIGH” position. (See Fig. 16-17)
NOTE: If the grill will not light after several attempts
see the trouble-shooting section of this manual. Turn
the control knobs to the OFF position when not in use.
12
Do not attempt to
“Light” the grill if the
odor of gas is present!!
Fig. 15
Fig. 16
Fig. 17
Lighting the Grill
Crossover Burner