Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
16
INSTALLATION
GAS HOOKUP
LPG CYLINDER RESTRAINT FOR BUILTIN INSTALLATION
If the grill is to be installed in a Built-in application, then the grill must be installed in accordance with the
Built–in installation guidelines.
If you intend to operate your Built-in grill on LPG gas utilizing a minimum 9 kg cylinder, then the Built-in LPG cyl-
inder restraint must be installed prior to initial use of the grill. If you do not have one please contact DCS by Fisher
& Paykel for information on obtaining one. See section ‘Service’ for contact details.
The following steps will illustrate how to properly locate and install the LPG cylinder restraint within the Built-in
enclosure.
NOTE:
The grill comes with the LPG Regulator/Hose assembly installed at the factory. The assembly, along with the entire grill
system, is leak tested.
Do not remove the Regulator/Hose assembly from the grill during installation.
FIG. 13
457mm
max.
The maximum distance from the centre
of the manifold cut out to the centre of
the cylinder restraint is 457 mm.
Centre of manifold cut
out projected to floor
of the island.
Centre of Cylinder Restraint must
be placed within this area to
avoid causing stress on the LPG
regulator hose connection.