Fire Magic E1060 Gas Grill User Manual


  Open as PDF
of 38
 
11
REV 1 - 0809031556
L-C2-28708
INSTALL THE TOOL HOLDER AND
PAPERTOWEL HOLDER
The rectangular mounting bracket for the tool
holder and the paper towel holder come pre-
attached to the sides of the cart.
Unpack the holder portion, squeeze the open
ends together slightly, and install them into the
mounting bracket (see Fig. 11-2). Next, release
the hanger so that the ends extend out through
the holes in the top and bottom of the mounting
bracket (Fig. 11-3, 11-4).
When not in use, the racks may be folded back
against the wall of the grill (Fig. 11-3, 11-4).
LOCATION PREPARATION
Prepare a fl at, level surface capable of supporting
the weight of the stand-alone grill and convenient to
the gas supply if connecting to a gas line.
WHEELS AND CASTERS
To lock a caster press down on the side of the lever
with the word "OFF" stamped on it until it stops and
the caster will not turn. To unlock, press down on the
side stamped "ON."
INSTALLING THE STAND-ALONE UNIT
Fig. 11-1
Caster in locked position
Fig. 11-2
Fig. 11-4
Fig. 11-3
CONNECTING THE GAS SUPPLY
For connecting a propane unit to a portable
propane tank, read the safety warnings and
follow the instructions in the section SAFE USE
AND MAINTENANCE OF PROPANE GAS
CYLINDERS.
For household propane or natural gas units:
a. Turn OFF the gas supply at the source. The
quick disconnect hose is pre-installed on the
valve manifold at the manufacturer. Run the
hose through the hole in the bottom rear of the
stand-alone unit, to the gas supply. Connect
the
1
/
2
" NPT socket at the end of the hose to
the gas supply. Use pipe joint compound that is
resistant to all gasses on the male pipe fi tting
and tighten securely. DO NOT use pipe joint
compound to connect the fl are fi ttings.
c. Turn all burner valves to the OFF position. Turn
the gas supply on. Then carefully check all gas
connections for leaks with a brush and soapy
water before lighting. NEVER USE A MATCH
OR OPEN FLAME TO TEST FOR LEAKS.
 previous next