Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
15
NORMAL OPERATION
NORMAL OPERATION
Match Lighting Your Grill Side Burner
Follow the simple steps listed below to match light the Side Burner of grill, in the event
snap ignition fails:
1. Open the lid and make sure that all burners are in the “OFF” position.
ƽ DANGER: Failure to open the lid while igniting the Side
Burner, or not waiting 5 minutes to allow the gas to clear if
the Side Burner does not light, may result in an explosive
flame-up which can cause bodily injury or death.
2. Turn main gas supply on.
3. Put match in the match holder and strike match.
ƽ WARNING: Do not lean over an open barbecue.
4. Select the Front or rear SIDE BURNER.
5. Push in Side Burner control knob and turn to “high”.
6. Insert match holder and lit match through trivet to ignite the Side Burner.
ƽ WARNING: If burner does not light, turn the Side Burner
control knob to OFF and wait 5 minutes to let the gas clear
before trying again to light burner.
7. Verify Side Burner has ignited by visual inspection of a fl ame.
Side Burner Snap Ignition
Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner
lighting tube. You generate the energy for the spark by pushing in the control knob and turning to
“START/HI”. This will ignite each individual burner.
Follow the simple steps listed below to light the Side Burner (SB) of your grill:
ƽ DANGER: Failure to open the lid while igniting the side
burner, or not waiting 5 minutes to allow the gas to clear
if the side burner does not light, may result in a explosive
flame-up which can cause bodily injury or death.
1. Open the lid and make sure that all burners are in the “OFF” position.
2. Turn main gas supply on.
3. Select the Front or rear SIDE BURNER.
4. Push the control knob in and turn to “START/HI” until you hear the igniter snap -
continue to hold control knob in for two seconds. This action will spark the igniter,
the burner lighting tube and then side burner.
5. Check that the burner is lit by looking through the cooking grates. You should see
a fl ame. If burner does not light on fi rst try, push control knob in and turn to OFF.
Repeat lighting procedure a second time.
6. Verify Side Burner has ignited by visual inspection of a fl ame.
ƽ WARNING: If ignition still does not occur, turn control knob
OFF and wait 5 minutes before manually lighting the burner
with match. See Match Lighting instructions.
4
1
5
4
1
5
Rotisserie Burner Electronic Ignition
Follow the simple steps listed below to light the Rotisserie Burner of your grill:
ƽ DANGER: Failure to open the lid while igniting the Rotisserie
Burner, or not waiting 5 minutes to allow the gas to clear
if the Rotisserie Burner does not light, may result in a
explosive flame-up which can cause bodily injury or death.
ƽ CAUTION: The Rotisserie Burner flame may be difficult to see
on a bright sunny day.
1. Open the lid and make sure that all burners are in the “OFF” position.
2. Turn main gas supply on.
3. Remove warming rack. NOTE: Always remove the warming rack when using the
rotisserie.