Desa (V)CD36RP Outdoor Fireplace User Manual


  Open as PDF
of 52
 
www.desatech.com
116035-01E36
Figure 68 - Typical Flame Pattern
OPERATING FIREPLACE
Continued
Note for BKT Only: If you are using BKT
blower with optional thermostat (wall mounted
orremotecontrol)forthereplace,yourre-
place and blower will not turn on and off at the
sametime.Thereplacemayrunforseveral
minutes before the blower turns on. After the
heater modulates to the pilot position, the blow-
er will continue to run. The blower will shut off
afterthereboxtemperaturedecreases.
The blower helps distribute heated air from
thereplace.Periodicallycheckthelouversof
thereboxandremoveanydust,dirtorother
obstructionsthatwillhindertheowofair.
Figure 65 -
Setting the Selector Switch, Gas
Control Knob and Variable Control Knob for
Remote Operation
Thermocouple
Thermopile
1/8"
Pilot Burner
Piezo
Ignitor
Figure 66 - Pilot Assembly (Millivolt)
3/8" to 1/2"
INSPECTING BURNERS
Check pilot ame pattern and burner ame pat-
terns often.

The pilot assembly is factory preset for the proper
ame height. Alterations may have occurred dur-
ing shipping and handling. Call a qualied service
person to readjust the pilot if necessary.
The position and pattern of the pilot ames in rela-
tion to the sensing devices should be as shown in
Figures 66 and 67 depending on model.
Figure 67 - Pilot Assembly (Electronic)

Burner ames will be steady; not lifting or oating.
Flame patterns will be different from unit to unit
and will vary depending on installation type and
weather conditions.
If the vent conguration is installed incorrectly,
the ames will lift or "ghost". This can be danger-
ous. Inspect the ames after installation to ensure
proper installation and performance.
Figure 68 shows a typical ame pattern.
If burner flame pattern differs from that de-
scribed:
• turn replace off (see To Turn Off Gas to Ap-
pliance, page 32 or 35 depending on model)
• see Troubleshooting, page 38
O
F
F
P
I
L
O
T
L
O
I
H
ON
OFF
REMOTE
ON
OFF
O
N
Sensor
Rod
Pilot
Burner
Piezo
Ignitor
If you pilot assembly does not meet these require-
ments:
• turn replace off (see To Turn Off Gas to Ap-
pliance, page 32 or 35 depending on model)
• see Troubleshooting, page 38
 previous next