Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
22
105542
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
CHDV37N/P(A,B) AND CHDV41N/P(A,B)
INSTALLING OPTIONAL
BRICK LINER CD8037A/
CD8041
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before
installing brick liner.
This brick liner kit is optional. You may
purchase brick liner from your local retailer
or see Accessories, page 33.
CAUTION: Always handle
brick panels with two hands. Do
not force brick panels into place.
Excessive force will break brick
panels.
1. Remove glass door. See Removing/Re-
placing Glass Door, page 21.
2. If installing brick liner in new fireplace,
go to step 3. If installing brick liner in
an existing fireplace, carefully remove
logs, lava rock, and ember material.
3. Install left side brick panel first by slid-
ing it between the grate and the side of
the firebox (see Figure 44).
4. Slide the left retainer bracket against
the left side brick panel. Loosely se-
cure the bracket screw. This secures the
left side brick panel.
5. Install the right brick panel using the
same method described in step 3.
6. Slide the right retainer bracket against
the right side brick panel. Loosely se-
cure the bracket screw. This secures the
right side brick panel.
Figure 45 - Installing Rear Brick Panel and Retainer Brackets
Figure 44 - Installing Left Side Brick Panel
FIREPLACE
INSTALLATION
Continued
Left Side
Brick Panel
Retainer
Brackets
Rear Brick Panel
Retaining Brackets
Attaching Magnetic Decorative
Brass Strips
This fireplace comes with a set of two mag-
netic decorative brass strips. Before attach-
ing strips to fireplace, remove plastic film
from brass pieces. After installing door,
attach these strips to the top and bottom of
glass door frame.
7. Install rear brick panel. Rest bottom
edge of panel on back edge of grate (see
Figure 45).
8. Loosely secure retainer brackets to grate.
Brackets are adjustable left to right to
allow proper placement of panel. These
will hold rear panel in place.
9. Tighten all bracket screws.
10. Follow instructions on page 23 to install
logs, lava rock, and ember material.
11. Replace glass door (see page 21).