Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
116236-01G 31
INSPECTING BURNERS
Continued
Burner ames will be steady; not lifting or oating.
Flame patterns will be different from unit to unit
and will vary depending on installation type and
weather conditions.
If the vent conguration is installed incorrectly,
the ames will lift or "ghost". This can be danger-
ous. Inspect the ames after installation to ensure
proper installation and performance.
Figure 50 shows a typical ame pattern.
If burner flame pattern differs from that de-
scribed:
• turn replace off (see To Turn Off Gas to Ap-
pliance, page 28)
• see Troubleshooting, page 33
Figure 50 - Typical Flame Pattern
CLEANING AND
MAINTENANCE
GLASS DOOR
WARNING: Do not use
-
Glass must be cleaned periodically. During start-
up it is normal for condensation to form on the
inside of the glass causing lint, dust and other
airborne particles to cling to the glass surface.
During initial start-up a slight lm may form on
the glass due to paint curing. The glass should be
cleaned several times with a non-ammonia, non-
abrasive household cleaner and warm water after
the rst two weeks of operation. Thereafter, clean
the glass two or three times during each heating
season, depending on the usage and circumstances
present. Refer to Removing/Replacing Glass Door,
page 25 of this manual when removing glass door
for cleaning.
-
(see Replacement Parts
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
25). Vacuum all glass pieces with a shop vac.