Dacor OB36 Gas Grill User Manual


 
17
Installation Instructions
With the tank shelf open, connect the power cord from
the outdoor grill and the warming oven (if equipped with
one) to the electrical outlet on the back panel inside the
cart.
Connect the rotisserie motor power cord to the
electrical outlet on the back side of the cart.
Power Connection - Cabinet Installations
Connect the appliance(s) to an electrical outlet
that meets the specifications in the Planning the
Installation section.
The rotisserie motor should be plugged into the same
outlet or an alternate 120 Vac outlet on the same circuit
as the appliance.
Verifying Proper Operation
Lighting Instructions
Read and understand the accompanying use & care
manual prior to cooking with this appliance. The use
and care manual contains additional important safety,
service and warranty information.
No adjustment of burner settings is required. All valves
and air mixture shutters found in this appliance have
been factory preset.
With the main gas supply valve on, turn all burner
knobs to the HIGH position for approximately 20
seconds to allow the air in the system to purge from the
grill and cooktop side burners.
Once the gas has filled the lines the automatic
electronic ignition system should ignite the burner. If the
system burners do not ignite within 20 seconds turn all
burner controls to the OFF position. Wait five minutes
and attempt the ignition process again.
Visually check the burner flame for proper operation.
Proper flame operation will show a steady, soft blue
color and stable flame.
2.
3.
1.
2.
3.
4.
5.
If the second or third attempt to ignite the burner is
not successful then turn all burner controls to the OFF
position.
If the grill or cooktop fails to operate properly, ensure
that the electrical power supply and gas supply are
turned on and that all installation steps have been
carefully followed. Check the ground fault interrupter(s)
on the electrical outlet(s) to make sure that it is not
tripped. Push the black button to reset.
If the grill still will not light, turn off the main gas line
control valve or LP tank control valve and contact the
Dacor Customer Service Team at (800) 793-0093, to
schedule a service call.
Installation Checklist
WARNING
To ensure a safe and proper installation, the
following checklist should be completed by the
installer to ensure that no part of the installation has
been overlooked.
Proper installation is the responsibility of the
homeowner. The importance of proper installation
of your Dacor Outdoor Grill cannot be over
emphasized.
Is the electrical outlet for the appliance grounded
and located according to these instructions and in
accordance with all applicable electrical codes for
outdoor appliances?.
Is the gas service for the appliance located and
installed according to these instructions and in
accordance with all applicable codes?
Has the gas supply inlet pressure been measured to
ensure that it does not exceed the maximums and
meets the minimum stated in these instructions?
Is the applaince secured to the cabinet or cart?
Are the grease tray, flame spreaders, grates and, if
applicable, burner heads and caps properly installed
according to these instructions?
Has proper operation been verified? Did the installer
check the gas supply for leaks?
Have any problems been noted on the warranty card
or during the on-line warranty activation? Has the
warranty been activated on-line or the warranty card
filled out completely and mailed?
6.
7.
8.
Electical Outlet with Ground Fault Interrupter
Push to reset