Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
ÖÖ
Assemble the Motor Mount
Bracket to the right outside of
the Firebox.
ÖÖ
Assemble the Rotisserie to
the Firebox.
Step
25
Hardware shown actual size
(TN)
M6 x 15mm Screw
(2) Qty.
(UO)
M6 Locking Hex Nut
(2) Qty.
25-A
TN (x2)
UO (x2)
Motor Mount Bracket
25-C
Handle
Set Collar
Fork
Slip Collar
Fork
Spit Rod
NOTE:
Machined
Groove
Toward
Handle
25-D. Insert Pointed Tip of the Spit Rod into the Motor.
ÖÖ
Place Slip Collar on Firebox Wall. Make sure
the pointed tip of the Spit Rod stays in the
Motor.
ÖÖ
Push Set Collar against the Slip Collar, provide
a small gap to allow the Spit Rod to freely turn.
ÖÖ
Tighten the thumbscrews on the Set Collar
and the Forks to hold in place.
25-A. Attach the Motor Mount Bracket to the metal side panel
using two Screws (TN) and two Hex Nuts (UO).
25-B. Slide the Motor onto the Motor Mount Bracket.
25-C. Loosely assemble the Rotisserie parts as shown in
Figure 25-C. Do not tighten the thumbscrews until prop-
erly positioned in step 25-D.
25-B
Motor
25-D
Set Collar
Slip Collar
Firebox
Wall
Pointed Tip
28
Small Gap here