Coleman 5055-710 Outdoor Fireplace User Manual


  Open as PDF
of 4
 
6a. Assemble screen door latch.
NOTE: Two hex nuts and latch bar
will assemble on the inside of the
screen door.
{
(See Note)
6b. Insert handle from outside.
Loosely assembly one hex nut.
The handle should freely turn.
Point the handle downward to
begin the next step.
6c. Slip latch bar onto handle
threads. Align “D” slot in latch bar
with flat on handle threads. The
latch bar should point toward the
left. Assemble the second hex nut
to finish the assembly. This hex
nut functions as a “jam nut”, and
will tighten against the first hex
nut assembled in Step 5b.
6d. Tighten the “jam nut” with
a wrench.
6e. Proper installation of the
latch assembly.
7. Install the firebowl.
8. Install two grates.
NOTE: An inch or two of sand should
be used in firebowl beneath the grate.
Assembly (cont.)
Handle
Latch
Bar
5. Turn frame right side up. Place Screen Assembly into frame. Make sure
door is centered between two Leg Assemblies, and can open and close properly.
4b. Align holes in the 3 screen
panels with the holes on outside
edge of the remaining screen
support ring. Attach with small
screws and hex nuts. Tighten all
screws and hex nuts on the
screen assembly at this time.
4c. Install screen door by inserting pins into hinge slots on the screen
hinge panel
 previous next