Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
2. Remove cooking grates, burner tents and tent frames.
3. Under grill remove soup can from grease clip.
4. Beneath grill bottom remove ignitor wires by pulling down
on ceramic insulator (A).
5. Under console disengage (A) clips by lightly pushing clip on
burner tube away from you and pull down. Remove burners
and shield from grill bottom.
6. Wipe ceramic electrodes (A) with rubbing alcohol and cloth.
7. Clean burners exterior with soap and water. Lay burners on
flat surface, insert garden hose (preferably with nozzle), into
burner tubes forcing water through tubes. Make sure water
comes out of every porthole. Open clogged portholes with a
thin wire. and examine portholes.
Due to normal wear and corrosion some portholes may
become enlarged, if so replace burner. If any horizontal
cracks appear from porthole to porthole or large holes (other
than portholes) are found replace burner. Use a wire brush
to clean carry-over tube.
Turn gas off at control knobs and gas source.
Shake out excess water
8. If grill is to be stored, coat burners lightly with cooking oil.
Wrap in protective cover to keep insects out. If not storing
use following steps.
9. Place shield into bottom of grill then burners. Attach burners
into valves, under grill bottom reattach clips.
10. Attach ceramic insulators with ignitor wire to burners.
11. Reposition cooking grates, tent frames and burner tents.
Reattach soup can to grease clip under grill bottom.
12. Before cooking again on grill, follow
VERY IMPORTANT: Burner tubes must engage valve
openings as shown.
“Burner Flame Check”.
14 • 4638234
Valve
Clip
Burner
Tube
Ceramic
Insulator
A