Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
20
12
Inside of cart, insert rear tank heat shield tabs(w/o holes) into slots on the bottom of upper back panel.
Attach FireBox lower heat shield to the tank heat shield using two #8x3/8” self-tapping screws, shown A.
Attach front tank heat shield tabs(w/ holes) under front brace using two #8x3/8” self-tapping screws, shown B.
#8x3/8” self-tapping
screw
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module.
Total (4) connections.
Connect the two wires[(a) and (b)] from
the switch wiring harness into the back
of the Electronic Ignition Module.
NOTE: Switch
terminals are larger than electrode
terminals and should only be
installed in location shown as (a),(b).
Total (2) connections.
ignition module
Electronic
Heat shield
Left side panel
A
A
B
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown A.
Insert AA battery into ignition module, negative (
-) end first. Then put on the cap, shown B.
Nut
-
+
AA batteryCap
3
1
2
4
(a)
(b)
Tank heat shield
FB lower heat shield
FB lower heat shield
Tank heat shield
Tab w/ hole
Tab w/o hole
(rear)
(front)
(concave faces up)
Front brace
Upper back panel
Tank heat shield
#8x3/8” self-tapping
screw
side view
B