Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
#8-32x3/8” screw
4mm
lock washer
Control knob
Control knob
bezel
Sideburner
valve bracket
Screws and Washers
removed from valve bracket
Sideburner
fascia
Valve stem
8a
A) Insert the Electronic Ignition module into the hole of
B) Insert AA battery into ignitor module, negative (—) end first, screw on the ignition button.
C) Connect main burner ignitor wire to the terminal on backside of electronic ignition module. Connect one end of
side burner ignitor wire to side burner electrode and other end to the back of electronic ignition module.
left fascia, secure with the plastic nut.
9
B
C
Some components are not
shown for the clarity of
illustration
Side Burner Electrode
Side Burner Wire
Main Burner Wire
.
A
10
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Install bezel with “OFF” at top.
Note: Use left and right
holes on fascia to
attach valve bracket
Note: Use upper and lower
holes on fascia to
attach bezel
20 • 463248208