Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
463240804 • 17
WARNING
If “growing” bubbles appear do not use or move the LP tank.
Contact an LP gas supplier or your fire department!
Connecting Regulator To The LP Tank
1.
2.
3. full
stop
4.
LP tank must be properly secured onto grill. (Refer to
assembly section.)
Turn all control knobs, including sideburner, to the OFF
position.
Turn LP tank OFF by turning hand-wheel clockwise to a
.
Remove the protective cap from LP tank valve. Always use
cap and strap supplied with valve.
Safety Relief Valve
Nipple has to be centered
into the LP tank valve.
OPD Hand Wheel
Type 1 outlet with
thread on outside
O
f
f
C
l
o
c
k
w
i
s
e
Do not use a POL transport plug
(plastic part with external threads)!
It will defeat the safety feature of
the valve.
Strap and Cap
LP Tank Exchange
LP Tank Leak Test
• Many retailers that sell grills offer you the option of replacing
your empty LP tank through an exchange service. Use only
those reputable exchange companies that inspect, precision fill,
test and certify their cylinders.
Always keep new and exchanged LP tanks in upright position
during use, transit or storage.
•
Leak test must be repeated each time LP tank is exchanged or
refilled.
Do not smoke during leak test.
Do not use an open flame to check for gas leaks.
Grill must be leak tested outdoors in a well-ventilated area,
away from ignition sources such as gas fired or electrical
appliances. During leak test, keep grill away from open flames
or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution.
Exchange your tank only for
an OPD safety feature-equipped tank as described in the
"LP Tank" section of this manual.
•
Leak test new and exchanged LP tanks BEFORE
connecting to grill.
For your safety
•
•
•
•
s Do not use household cleaning agents. Damage to gas
train components can result.
Brush soapy solution onto areas indicated by arrows
in figure below.
5. Make sure hose and regulator pass
UNDER hose bracket on cart (
). Hold regulator
and insert nipple into LP tank valve.
Hand-tighten the coupling nut, holding
regulator in a straight line with LP tank
valve so as not to cross-thread the
connection.
see
last assembly step