Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
VERY IMPORTANT: Burner venturi must be attached with orifice
holder properly. see illustration below.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
venturi tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner venturi tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
10.
Wire brush entire outer surface of burner to remove food
residue and dirt.
11.
Clean any blocked ports with a stiff wire such as an open
paper clip.
12.
Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
13.
After cleaning put the burner back into the firebox and attach
the electrode wire onto the electrode connector under the
burner.
14.
Place burner into position and reinstall the hitch pin.
15.
Under the firebox, attach the orifice holder with the venturi tube.
16.
Replace the grease pan, tank heat shield, greasy tray, radiator
plate, and cooking grates.
Correct
engagement
with the screws previous removed.
Reinstall
Screws
NOTE:
10