Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 10
5
• Place unit in upright position.
• Attach small hinge half to smoker chamber using two #10-24
X 1/2” screws and two #10-24 flange nuts for each hinge half.
Install screws from inside the smoker chamber.
• Attach large hinge half to smoker chamber lid using two #10-
24 X 1/2” screws and two #10-24 flange nuts for each hinge
half. Install screws from inside the smoker chamber lid.
• Insert top hinge in between bottom hinge and secure using
one hinge pin and one hitch pin for each hinge set.
Finger tighten all screws and nuts in this step until all are
in place. Once all are in place, close the lid and fully
tighten all screws and nuts.
Small Hinge Half
Screws
Nuts
Large Hinge Half
Smoker
Chamber
Lid
Smoker
Chamber
Hinge Pin
Hitch Pin
6
• Insert smoke stack through smoker
chamber lid, aligning holes.
• Attach using two #10-24 X 1/2” screws and
two #10-24 flange nuts.
Fully tighten all screws and nuts.
Smoke Stack
Screw
Nut
on inside of
Lid
NOTE: Lid side wall shown
transparent for clarity