Vermont Casting 6100 Gas Grill User Manual


 
MATCH LIGHTING
Locating the Match Lighting Hole
Repeat steps 1 to 4 of “Igniter Lighting
Instructions.”
STEP 5. To match light: push down and turn
the RIGHT burner control knob
counterclockwise to the high setting.
STEP 6.
IMMEDIATELY strike a long wooden match
and position the burning match through match
lighting hole in the grill bottom. Extend the
flame near a burner port in the bottom edge of
the burner. The burner should light.
To light the other side of the burner, press in
and turn the opposite control knob. The flame
will track around the burner. Allow grill to
preheat with the grill lid closed for five to ten
minutes before cooking.
The match lighting hole is located beneath the
lower right corner of the grill bottom casting.
30
CAUTION: Do not touch any hot grill parts.
The outside of the grill bottom becomes very
hot during use. It may be necessary to use
protective gloves.
STEP 1. Turn the burner-control knob(s) off.
The burner flame will go out.
STEP 2. Turn off the top L.P. cylinder valve
by turning the knob in a clockwise direction
until it stops.
IMPORTANT: Always have the gas shut off at
the L.P. cylinder valve when the grill is not in
use. The L.P. cylinder has a leak detection
feature which will restrict the amount of gas
flow to the burner if the tank shut-off valve has
not been turned off prior to the next use.
HOW TO SHUT OFF THE GRILL
Lighting Instructions
IMPORTANT: The match lighting hole is
found under the front right corner of the grill
bottom. When match lighting the grill, use the
gas control knob on your RIGHT-HAND side
(closest to the match lighting hole).