Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
17
1
2
3
4
5
The instructions stated on gas cylinder tanks have to be followed when filling or transporting
tanks. Failure to do so could result in problems relating to overfilling, excessive venting release
of gas and to regulator freezing.
. The knob on the LP tank must be closed. See that the knob is turned
clockwise to a full stop.
. Check that the control knob on the smoker is turned off.
. Remove the protective cap from the LP tank valve and coupling nut,
if present.
. Hold the regulator in one hand and insert the nipple into the valve
outlet. Be sure the nipple is centered in the valve outlet. The
coupling nut connects to the large outside threads on the valve outlet.
Use care - do not cross thread the connection.
. Hand tighten the coupling nut clockwise until it comes to a full stop.
Firmly tighten by hand only. Do not use tools.
CAUTION: In the connection process, the HVR side of the connection
will seal on the back check in the valve, resulting in a slight resistance.
The connection requires about one-half to three-quarters additional
turn to complete the connection.
Any fuel supply cylinder used must be constructed and marked in accordance with specifications for
propane cylinders of the U.S. Department of Transportation (DOT) CFR 49, or CAN/CSA B339. The
appliances is to be used only with the 20 pound, vertical standing vapor withdrawal type tank.
This smoker is designed to operate on LP (Liquefied Propane) gas only.
The 20 lb LP cylinder used with this smoker must conform to the following requirements.
Diameter- 12” (30.5cm)
Height 18” (45.7cm)
With a maximum capacity of 20 pounds
The gas cylinder used must include a collar to protect the cylinder valve. The cylinder supply system
must be arranged for vapor withdrawal.
Do not allow dirt or foreign material to get into or onto tank connection when it is not attached to the fuel
supply system. Place the dust cap on cylinder valve outlet whenever the cylinder is not in use. Only
install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other
types of caps or plugs may result in leakage of propane.
Connecting the LP Tank
(A) Do not store tanks under or near the smoker.
(B) Never fill tanks more than 80% full.
If instructions A and B above are not followed exactly, a fire causing death or
serious injury may occur.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE
FOLLOWED TO PREVENT FIRE, DAMAGE, AND / OR INJURY.