Centro G51208 Gas Grill User Manual


 
12 13
ASSEMBLY INSTRUCTIONS
12
ASSEMBLY INSTRUCTIONS
12
13
a. Position the Sear Zone burner (DD) through
the opening in the left side shelf (DA).
b. Make sure that the Sear Zone burner (DD) en-
gages the Sear Zone burner valve (CC), gas jet,
as shown in  gure B.
c. Assemble the Sear Zone burner (DD) to the
Sear Zone support frame (DC1), at the 4 points
indicated in  gure C.
d. Feed the Sear Zone electrode wire (DE) from
underneath the Sear Zone burner (DD), through
the small opening on the right side of the Sear
Zone support frame (DC1). Align and assemble
the electrode using the self tapping screw pro-
vided, as shown in  gure D.
DD
DD
DDDC1
CC
DA
DC
DE
A
B
C
D
876
6
YOU WILL NEED:
YOU WILL NEED:
6
14
7 8 13
X 4
X 1
X 4 X 4 X 4
YOU WILL NEED:
9
Place the heat shield (CP) into the groove
which is located at the back side of the front
brace (CL) as shown in  gure A. Next, attach
the heat shield (CP) to the upper back panel
(CO) by using the self tapping screws (X 4), as
shown in  gure B.
X 4
B
A
e. Attach the end of the side burner electrode
wire (DE) to the underside of the side burner
electrode, as shown in  gure E.
Ensure that the wire is pushed in  rmly.
DE
E
f. Position either the Sear Zone cooking griddle
(DI) or the cooking grate (DH) in position on
the Sear Zone side burner side shelf. Store the
extra accessory within the BBQ chart.
F
G
DI
DH
CP
CP