Centro 4000AS Gas Grill User Manual


 
9
TROUBLESHOOTING GUIDE
Corrective Action
Clean out blockage
Open cylinder or gas supply valve
Ensure proper Venturi assembly
Clean/replace burner
Refill cylinder
Follow How to Reset the Gas
Regulator Safety Device (page 5)
Tighten regulator fully (hand tighten) onto cylinder
Straighten fuel hose
Clean out blockage
Clean burner
Check all connections are tight
Ensure collector box, burner and
igniter are assembled properly
Replace igniter
Relocate barbecue back towards wind
Refill cylinder
Trim meat, turn down burner controls
and/or fuel supply
Clean casting base and burner
Position cooking system correctly
Immediately shut off gas at source,
allow grill to cool and clean out Venturi tubes
Temporary condition caused by high outside
temperatures and a full propane cylinder
Clean/replace burner
The warming rack legs are adjustable.
Please bend to fit into the warming rack holes
Possible Causes
Blocked Venturi tubes
Cylinder or gas supply valve turned off
Venturi tubes not properly sealed over orifices
Burner ports blocked
Low or out of propane
Regulator safety devise must be re-set
Regulator not fully tightened into cylinder
Partially blocked Venturi tubes
Excess cooking salts on burner
Loose wire connection
Broken electrode
Poor ground
Faulty igniter
High wind conditions
Propane low
Excessive fat in meat
Grease drain plugged
Cooking system not positioned correctly
Blocked Venturi tubes
This is not a defect or a hazard
Plugged, rusted or leaking burner
Legs are angled too narrowly, or widely
Problem
Burner will not light
(match or igniter)
Burners not hot enough
Flames smoky yellow
Burner lights with match
but not with igniter
Flame blows out/down
through base
Too much heat/excessive
flare-up
Flames under heat
control console
Regulator humming
Incomplete flame
Warming rack
will not fit
For more troubleshooting support or parts ordering, please call toll free
1-877-707-5463.