Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
LIGHTING
A. LEFT BURNER CONTROL G. HANDLE
B. RIGHT BURNER CONTROL H. SIDE BURNER
C. SIDE BURNER CONTROL I. SHUT OFF VALVE
D. REAR BURNER CONTROL J. QUICK DISCONNECT COUPLING
E. IGNITOR K. GAS SUPPLY PIPING
F. MANUAL LIGHTING HOLE L. GAS SUPPLY HOSE
1. The appliance must be assembled as per the assembly
instructions.
2. Check that your gas cylinder is full and properly
connected to the regulator.
6
3. Check that there are no gas leaks in the gas supply
system. See Leak Testing.
4. Check that the venturi tubes are properly located over
the gas valve orifices.
5. Check that both Main Burner and Side Burner ignition
wires are connected.
6. Read carefully all instructions contained on the
information plate attached to the barbecue.
7. WARNING: Open lid before lighting.
8. Set control knobs to "OFF" and turn on the gas supply.
9a. For Main Burner:
Push and turn either main burner control knob to
"HIGH".
Push or rotate the ignitor knob 3 or 4 times or match
light.
Burner should ignite within 5 seconds.
(Ignition may perform better with right control knob or
both control knobs set at medium.)
Note: To light burner with a match follow steps 1
thru 8 above.
Insert lighted match through lighting hole located at the
bottom right of the grill housing.
Push and turn right main burner control knob to "HIGH".
Burner should ignite within 5 seconds.
After the right burner is lit, push and turn left main
burner control knob to "HIGH". Left burner will ignite
automatically.
9b. For Side Burner:
Push and turn side burner control knob to "HIGH."
Push or rotate the ignitor knob 3 or 4 times.
Burner should ignite within 5 seconds.
Note: To light burner with a match follow steps 1
thru 8 above.
Apply lighted match to burner ports.
Push in the control side burner knob and turn to
"HIGH".
Burner should ignite within 5 seconds.
9c. For Rear Burner Rotisserie:
Warning - Do not operate the main burner
simultaneously with the rear burner as this may result in
a grease fire and/or damage to the barbecue.
Caution: Rear burner must be in place before
operating the control knob.
REMOVE THE WARMING RACK.
Follow steps 1 thru 8.
Place lighted match near rear burner ports.
Push and turn rear burner control knob to "HIGH".
Burner should ignite within 5 seconds.
It is important to have lighted match near burner ports
BEFORE turning the control knob.
10. Caution - Check your barbecue after lighting.
CHECK FLAME BURNER
BURNER PORTS
All the ports on
the burner
should show a
2.5cm flame on
"HIGH" setting.
If any of the following symptoms occur there is
probably a blockage in the venturi tubes. Shut off gas
at once and clean the venturi tubes. See "Venturi
Tubes".
1. You smell gas.
2. If a flashback fire occurs.
3. Your barbecue heats unevenly.
4. The burners make popping noises.
IF BURNER DOES NOT IGNITE:
1. Push and turn control knob to "OFF".
Wait 5 minutes, then try again with right control knob or
both control knobs set at medium.
2. If any burner will not light, consult "Trouble Shooting
Guide". If problem cannot be resolved, do not attempt
to operate the appliance; contact your dealer or
approved service centre.
SHUT DOWN
1. Turn off supply valve.
2. Turn control knobs to "OFF".