Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
B101623-2-0112 Page 25
Installing the Ignitor
Caution: Do not cut or damage ignitor wire.
Carefully thread the end of the ignitor wire through the center hole
in the grill bottom. Slide the ground lug over the ignitor wire and
fasten with nut provided.
Attach one end of the ground wire to the terminal on the rear of
the electronic ignitor. Attach the remaining end to the ground lug.
See Figures 8 and 9.
Attach ignitor wire to the spark terminal on the rear of the electronic
ignitor.
Figure 9
GRILL ASSEMBLY
Nut
Figure 8
Ignitor Assembly
Slide the collector box spacer and nut (provided on assembly) onto
the collector box shaft and tighten. See Figure 8.
Note: Peel protective lm from control panel label before
installing ignitor.