Broilmaster H4X-1 Gas Grill User Manual


 
B101623-5-1012 Page 25
Installing the Ignitor
Caution: Do not cut or damage ignitor wire.
Carefully thread the end of the ignitor wire through the center hole
in the grill bottom. Slide the ground lug over the ignitor wire and
fasten with nut provided.
Attach one end of the ground wire to the terminal on the rear of
the electronic ignitor. Attach the remaining end to the ground lug.
See Figures 8 and 9.
Attach ignitor wire to the spark terminal on the rear of the electronic
ignitor.
Figure 9
GRILL ASSEMBLY
Nut
Figure 8
Ignitor Assembly
Slide the collector box spacer and nut (provided on assembly) onto
the collector box shaft and tighten. See Figure 8.
Note: Peel protective lm from control panel label before
installing ignitor.
Installing Control Knobs
Place control knobs onto valve stems. The knobs will only t onto
the stems one way.