Broilmaster BDA-1 Gas Grill User Manual


 
Page 10 B101502-3-1012
10. Install each of the four vent covers (BRB Vent Register
Kit) into the Built-In Kit Enclosure using two #8 x 3/4”
screws. See Figure 9.
BHa & BHaX asseMBly
Figure 9
Figure 10
Alternate Match Lighting Instructions
1. Turn the burner control knobs clockwise to the OFF
position.
2. Turn ON gas at the source.
3. Open the grill lid.
4. Open the BHA access door. Locate the Ignitor Rod,
which is permanently attached to the inside of the
Bottom Shelf.
5. Insert an unlit match into the coiled end of the ignitor
rod. Light the match.
6. Insert the ignitor rod inside the access door and through
the front left air hole located on the bottom of the grill.
Position the match near the rear left corner of the burner.
See Figure 10.
7. Turn the left burner control knob counterclockwise to
HI.
8. If the burner fails to light after 5 seconds, turn the
burner control knob OFF for ve minutes then repeat
the procedure.
9. If the burner continues not to light, turn OFF all gas and
refer to the troubleshooting section of your grill Owner’s
Manual.