Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn control knob to HIGH and continue to push
knob in for 3 to 5 seconds to light burner.
4. Once burner is lit, continue to push knob in for 30 seconds.
5. If ignition does NOT occur in 5 seconds, turn control knob to
"OFF”, wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.
6. To turn off, turn control knob clockwise until it locks in the
"OFF" position.
IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.
Note: If burner does not light or flame is too low, you may have spider or other insect blockage in
burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance"
under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP
Cylinder and Hose/Regulator to Grill.
MATCH LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.
4. Push and turn the control knob to the "HIGH" position. Continue to push in control knob for 3 to 5
seconds while holding match under burner.
5. Once burner is lit, continue to push knob in for 30 seconds.
6. If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.
11
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn control knob to HIGH and continue to
push knob in for 2 to 3 seconds to light burner.
4. If ignition does NOT occur in 5 seconds, turn control
knob to OFF, wait 5 minutes to allow gas to dissipate
and repeat lighting procedure.
5. To turn off, turn control knob clockwise until it locks in
OFF position.
Note: If burner does not light or flame is too low, you
may have spider or other insect blockage in
burner, or the flow limiting device has been
activated. See "Burner Assembly/Maintenance"
under Proper Care and Maintenance, or
"Regulator Resetting Procedure" under
Connecting LP Cylinder and Hose/Regulator
to Grill.