Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
LIGHTING THE SIDE BURNER:
1. Open lid to the side burner before lighting.
2. Turn on the side burner by pressing in and rotating the
control knob to the HIGH position.
3. Press and hold the igniter button on the main control
panel for 3-5 seconds until the burner ignites.
4. If burner does not ignite immediately, turn the burner
control knob to OFF and wait 5 minutes for gas to
evacuate the grill. Repeat steps 1 through 4 until
burner ignites.
5. If burner does not ignite using the push button igniter
wait 5 minutes, see "Match Lighting the Side Burner" section.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to OFF.
3. Strike and place a long wooden match approximately 1/2" (2 to 3 cm) from the burner.
4. Turn the side burner control knob to the HIGH position. The burner should light immediately.
5. If burner does not ignite immediately, turn the burner control knob to OFF and wait 5 minutes for gas
to evacuate the grill. Repeat steps 1 through 5 until the burner ignites.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See “Trouble Shooting” section of this manual.
TURNING OFF THE GRILL:
1. Turn OFF the LP tank valve.
2. Turn all burner control knobs to the OFF position.
NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.
CAUTION!
• The LP tank valve should always be in the off,
or closed, position when the grill is not in use.
10
To turn off the LP tank valve,
turn knob clockwise until it stops.
MAXIMUM SIDE BURNER LOAD = 15 lbs.
1. Read and follow all warnings and instructions
in owner’s manual before lighting.
2. Open lid before lighting side burner.
3. Make sure all control knobs are in the OFF position.
4. Push and turn side burner control knob to HIGH.
5. Press the electronic igniter and hold for 3-5 seconds
to light burner.
6
.
If bu
rn
e
r d
oe
s N
O
T
ig
nite
im
m
ed
ia
te
ly
, tu
rn
co
n
tro
l kno
b to
O
F
F, w
a
it 5
m
in
ute
s to a
llow
g
as to
dissipa
te a
n
d re
p
eat
lig
htin
g p
roc
edu
re
.
7. Re
fe
r to
o
w
n
er
’s m
a
nua
l fo
r m
a
tch
lig
htin
g p
ro
ced
ure.
8
.
F
or a
s
s
ista
n
ce, ca
ll 1
-8
00-5
27
-0
717
.
9
.
To
turn
o
ff, turn co
ntro
l kn
ob
clo
ckw
ise
u
ntil it
lock
s in
O
F
F p
o
sition
.
SIDE BURNER LIGHTING INSTRUCTIONS:
NOTE: Observe flame height when lit: Flame
should be a Blue/Yellow color
between 1”–2” high.
2”
1”
0”