Brinkmann 810-6830-0 Gas Grill User Manual


 
4
WARNING
INSTALLATION INFORMATION:
The installation of this appliance must be in accordance with:
All applicable local codes, or in the absence of local codes, either:
National Fuel Gas Code ANSI Z223.1 NFPA 54
Natural Gas and Propane Installation Code: CAN/CGA B149.1
Natural Gas Installation Code: CAN/CGA B149.1 (Canada)
Propane Installation Code: CAN/CGA B149.2 (Canada)
To check local codes, please contact your local natural gas company. This grill was not intended to
be connected to an LP Gas Cylinder.
FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as a garage,
shed or breezeway.
Use your grill OUTDOORS in a well ventilated space away from dwellings or other buildings to
prevent dangers associated with gas accumulation and toxic vapors. We recommend your grill be
situated at least 10 feet (3.1 m) from buildings.
Maintain a minimum clearance of 36 inches (91 cm) between all sides of grill and walls or other
combustible material. DO NOT use grill under overhead unprotected combustible construction.
DO NOT use or install this grill in or on a recreational vehicle and/or boat.
GENERAL WARNINGS
WARNING
DO NOT use hard metal piping of any kind to connect this type of grill to a natural gas source.
Use only hose specified by manufacturer. Using hard metal piping or convoluted metal tubing is
an unsafe practice. Movement of the grill can cause breakage of metal pipe.
The appliance and its individual shut off valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of
1/2 psi (3.5 kPa).
The appliance must be isolated from the gas supply piping system by closing its individual
manual shut off valve during any pressure testing of the gas supply piping system at test
pressure equal to or less than 1/2 psi (3.5 kPa).
This grill is designed for natural gas use at 7 inch water column supply pressure. Verify supply
pressure with your local gas company. Not for use with LP gas.
Connections to gas source must be performed by a certified plumber.