Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
OPERATING INSTRUCTIONS
WARNING: Before using this outdoor fireplace, make sure you have read, understand and are following all
information provided in the Important Safeguards presented on page 3 and 4. Failure to follow those instructions can
cause death, serious injury or property damage.
Lighting
1. Make sure there is only a small amount of ash in the bottom of the bowl.
2. Place a layer of dry kindling or a natural firestarter such as Fatwood™ onto the center of the grate.
3. Place above that a layer of dry seasoned hardwood that is cut to lengths no more than 3/4 the diameter of the bowl.
4. Use a match to light kindling or firestarter.
5. Using the poker provided and heat-resistant gloves, replace spark guard once the kindling or firestarter is lit.
The poker provided may become hot during use and may remain hot after use.
Tending the Fire
You may need to shift and/or add logs for an ideal experience.
Do NOT place a hot spark guard or hot fireplace tools onto combustible surfaces such as grass, wooden deck or
furniture.
The poker provided may become hot during use and may remain hot after use.
Do NOT leave hot spark guard, poker, or other hot fireplace tools unattended, especially around children and pets.
1. Using the poker provided and heat-resistant gloves, carefully remove spark guard.
2. While using the poker provided and heat-resistant gloves, shift coals and logs to allow additional airflow.
3. Do NOT add gasoline, kerosene, diesel fuel, lighter fluid or alcohol to relight or enhance an existing fire.
4. Wait until glowing coals have developed before adding any additional wood. If additional wood is required, place wood on top
coals. Be careful not to shift ashes.
5. Using the poker provided and heat-resistant gloves, replace spark guard.
Extinguishing
1. Allow fire to burn itself out.
2. Do NOT use water to extinguish as this is dangerous and can cause damage to this outdoor fireplace.
CLEAN AND CARE
Inspecting
This outdoor fireplace should be inspected on a regular basis to ensure product safety and longer product life.
Do NOT attempt to inspect this outdoor fireplace until the fire is COMPLETELY out.
1. Check handles to make sure they are secure.
2. Check components for any signs of damage or rust.
3. If damage to any component is detected, do NOT operate until repairs are executed.
Cleaning
This outdoor fireplace should be cleaned on a regular basis to promote safer experiences and longer product life.
Note: After repeated use, a slight discoloration of the finish may occur.
Do NOT attempt to clean this outdoor fireplace until the fire is COMPLETELY out.
Do NOT use oven cleaner or abrasive cleaners as they will damage this product.
Do NOT clean any part of this outdoor fireplace in a self cleaning oven as it may damage the finish.
1. Wipe exterior surfaces with a mild dishwashing detergent or baking soda.
2. For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.
3. Rinse clean with water.
4. Remove built-up creosote from components with a chimney cleaning product.