Blue Rhino NSG4303 Gas Grill User Manual


 
23
Owner’s manual: model NSG4303 outdoor gas grill 1/14/04
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
24
Manual de usuario: parrilla de gas para exteriores, modelo NSG4303 1/14/04
Si necesita ayuda llame al 1-800-762-1142
No devuelva el artículo al lugar de compra.
Lighting your Grill
Main Grill Burners
1. Open lid before lighting burners
Attempting to light the burner with the lid closed may cause an
explosion!
Make sure there are no obstructions of airflow to the gas unit. Spiders
and insects can nest within and clog the burner / venturi tube at the
orifice. A clogged burner tube can lead to a fire beneath the appliance.
2. All valves must be in the OFF position
3. Turn on gas at cylinder
4. Push and turn control knob counterclockwise to HIGH
5. Press the electronic igniter button and hold for 5 seconds to light
burner.
6. If ignition does not occur in 5 seconds, turn burner control knob
OFF, wait 5 minutes, and repeat lighting procedure. Use a lit match
secured with the lighting rod provided to light burners manually, if
igniter does not light burner. Access the burners through the cooking
grid and heat plates. Position the lit match near side of the burner.
7. Set control knob to desired heat setting.
Important: Always use the lighting rod provided when lighting burners
with a match.
After lighting, please observe the burner flame, make sure all burner
ports are lighted
If burner flame goes out during operation, immediately turn the gas “off”
and open lid to let the gas clear for about 5 minutes before re-lighting.
Before cooking on this grill for the first time, operate the grill for
about 15 minutes with the lid closed and the gas turned on “high.”
This will “heat clean” the internal parts and dissipate odor from the
manufacturing processes and painted finish.
Clean your grill after each use, DO NOT use abrasive or flammable
cleaners, as it will damage the parts of this product and may start a fire.
Side Burner
1. Valve must be in the OFF position
3. Turn on gas at cylinder
4. Push and turn control knob counterclockwise to HIGH
5. Press the electronic igniter button and hold for 5 seconds to light
burner.
6. If ignition does not occur in 5 seconds, turn control knob OFF, wait
5 minutes, and repeat lighting procedure. Use a lit match near the
burner ports if ignitor does not light burner.
7. Set control knob to desired heat setting.
DANGER
Failure to open lid while igniting
the barbecue’s burners, or not
waiting 5 minutes to allow the
gas to clear if the barbecue
does not light, may result in an
explosive flame-up, which can
cause serious bodily injury or
death.
Caution
If BBQ is not in use, the gas
must be turned off at the supply
cylinder.
1/2"
12.7 mm
6.4mm
0mm
1/4"
0"
FF
H
I
G
H
Ignitor Control knob
Control knob settings
OFF
HIGH
LOW
Main
Burner
0"
0 mm
3/8"
9.5 mm
3/4"
19 mm