Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Outdoor Charcoal Grill Model No. NPC1827BLN
Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
page no.
4
Step
1
Attach plastic feet
Insert 2 plastic feet into left cart frame.
Step
2
Assemble frame
A. Attach left and right side frames to link beams using 4 sets of large screws (C),
large lock washers (L), and large washers (I).
B. Attach wheels to right cart frame using wheel axle and 2 sets of rubber spacers
(O), and nuts (D).
C. Snap hub caps onto wheels.
C
L
I
D
C
L
I
O
Step
3
Attach front panel and bottom grid
A. Slide front panel into clips on inside of front legs. Fasten with 2 sets of medium
screws (B), large lock washers (L), and large washers (I).
B. Place bottom shelf onto link beams.
B
L
I
Step
4
Attach side shelves
Attach side shelves to cart frame using 6 sets of medium screws (B), large lock
washers (L), and large washer (I).
B
L
I
B
L
I
B
L
I
Step
5
Attach handle and air vent
A. Attach handle to lid using 2 sets of heat resistant washers (J), large washers (I),
large lock washers (L), large wing nuts (G).
B. Attach air vent to lid using small screw (A), small lock washer (K) and small wing
nut (F).
J
I
L
G
F
K
A
Step
6
Attach hinges and slide
A. Attach hinges to bowl using 2 sets of medium screws (B), large washers (I), heat
resistant washers (J), large washers (I), large lock washers (L), and large wing
nuts (G).
B. Insert slide onto underside of bowl. Turn to lock into position.
C. Secure slide to bowl using medium screw (B), large washer (I), large lock
washer (L) and large wing nut (G).
I
I
L
G
B
J
I
L
G
Assembly Instructions
DO NOT RETURN PRODUCT TO STORE.
For assistance call 1.800.762.1142 toll free. Please have your owner’s manual and serial
number available for reference.
For Easiest Assembly:
• To avoid losing any small components or hardware, assemble your product on a hard level
surface that does not have cracks or openings.
• Clear an area large enough to layout all components and hardware.
• When applicable, tighten all hardware connections by hand first. Once the step is
completed go back fully tighten all hardware.
• Follow all steps in order to properly assemble your product.