Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
.
2.
WARNING
Do not attempt to use a cylinder with any other type of connection device.
Do not attempt to use a cylinder with a larger capacity
LP CYLINDER FILLING AND EXCHANGE
Some areas only allow you to exchange your empty cylinder tbr a replacement that is already full. Other areas
allow you to refill your cylinder. If you are in an area where you can refill your cylinder:
1. Use only a licensed dealer.
2. The dealer must first purge a new cylinder before filling.
3. Never fill a cylinder more than 80% lull by volume. Volume will vary by temperature. An empty
cylinder weighs approximately 18 pounds (8.2kgs). A full one approximately 38 pounds (17.3kgs).
4. Be sure the LP dealer checks the cylinder _br leaks after filling.
5. Do not release LP gas into the atmosphere, as it can unexpectedly ignite when mixed with air.
6. Contact a LP dealer to remove LP gas from a cylinder.
Only exchange your cylinder tbr one with an O.P.D. feature as shown above.
WARNING
A _osty cylinder valve indicates possible gas overfill. Close the LP valve and call your dealer
immediatelv.
WARNING
1. Never store any extra cylinders near your grill.
2. Keep cylinders out of direct sunlight and high heat.
3. Never fill your cylinder over 80% full by volume. This may cause release of gas t_Oln the safety
release valve.
4. Ilnmediately call your LP dealer or fire department should you hear, smell, or see escaping gas
/_Oln the cylinder.
5. Do not insert any type of foreign objects into the valve outlet.
The gas supply must be turned off at the LP-
gas supply cylinder when this outdoor cooking
gas appliance is not in use.
L'alimentation du gaz doit _tre fermde a la bouteille
de gaz de pdtrole liqudfie, lorsque cet appareil de
cuisson extdrieur u'est pas utilise.
LP CYLINDER LEAK TEST
A leak test should be done each time a cylinder is refilled or exchanged. Do
not smoke or use any type of flammable material in the area during this leak test.
Do not use an open flame to check [br leaks.
1. Test outside in a well ventilated area.
2. Use a paintbrush and a solution of 50% liquid soap and 50% water. Do
not use cleaning agents and they can damage the fuel supply parts.
3. Brush liquid onto areas highlighted with arrows.
4. Bubbles indicate a leak.
17