Aussie 6804T80SS1 Gas Grill User Manual


 
10
To reduce the risk of bodily injury from lifting, the following assembly steps #s 9 and 10 will require two people.
CAUTION
!
Step 11
Hood/Body To Cart Assembly
Lift the Hood/Body Assembly over the cart assembly and set it down until it rests on the inside top flanges of the cart.
Align the holes in the side of the Hood/Body with the holes in the Side Panel brackets. Insert four 1/4-20 x .50 Bolts
through the holes in cabinet flanges and into threaded inserts in firebox and tighten after all are installed.
Depress
Left Door shown,
Right Door same.
Right side
view
1/4-20 x .50” Bolt set
4 pc
Step 10
Door Assembly
Install LEFT Door. Drop bottom door pin into Cabinet Bottom Panel hole. Swing top of door toward hole in top of Left
Side Panel. Depress spring-loaded pin with thumb while sliding pin into Left Side Panel hole until it snaps into place.
Right Door assembly is similar; Fixed pin is under drawer and inserts into hole in door and spring-loaded pin is in the
BOTTOM of small door and functions the same.