Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
STORAGE
To reduce the risk of serious bodily injury or death:
· Store your LP gas grill in a cool dry place. Do not
store an LP gas cylinder in a space greater than 125
degrees Fahrenheit. Do not store an LP gas cylinder
in a building ,garage or any enclosed area.
· Do not store an LP gas cylinder indoors (empty or
filled). Disconnect the LP gas cylinder from the gas
grill and store it outdoors out of the reach of children.
The gas grill may then be stored indoors.
· To avoid an explosion, do not leave an LP gas
cylinder inside a vehicle that can become overheated
by the sun.
· Even though your LP gas cylinder may appear to be
empty, gas may still be present and the cylinder
should be transported and stored accordingly.
· Do not store a spare LP gas cylinder under or near
the LP gas grill.
· Always turn off the gas cylinder at the LP cylinder
valve when the gas grill is not in use.
1) Disconnect LP gas cylinder from grill and store outside, in
a dry, well-ventilated area, away from any sources of heat
or ignition. Re-cap LP cylinder valve with the Safety Cap.
2) Wrap the burners with aluminum foil to prevent insects
from entering the burner holes.
3) You may wrap the Cooking Grid and Flame Diffuser in
aluminum foil and place inside the Hood or store inside
your dwelling.
4) Place a grill cover over the grill and store the gas grill
outdoors if possible. It may be stored indoors only if the
LP cylinder is disconnected from the gas grill.
5) Before next use, remove aluminum foil from burners,
Flame Diffuser, and Cooking Grids.
6) Before using the grill after periods of storage or non-use
(i.e. over winter), check your LP gas grill for gas leaks,
deterioration, proper assembly, and burner obstructions.
7) Periodically check and tighten all nuts, bolts, and screws.
Problem
Possible Cause
Solution
Emergencies
Gas leaking from
cracked/cut/burned
hose.
Damaged hose.
Mechanical failure due to rust
or mishandling.
Failure of valve from mishan-
dling or mechanical malfunc-
tion.
Fire in or around venturi tube
section of the burner.
Too much grease build-up in
burner section.
Replace LP Cylinder
Turn off LP cylinder valve. Return cylinder to gas supplier.
If you can safely reach the control panel, turn off control knobs
then close the LP cylinder valve. Once fire is out and grill has
cooled off. Remove burner(s) and inspect for blockage from spi-
der webs/nests or rust. See “How to clean your burners.” sec-
tion. Replace any damaged parts.
Turn off control knobs and LP cylinder valve. Once fire is out
and grill has cooled off. Clean residual food particles and
excess grease from inside firebox area, grease cup and other
surfaces.
Turn off gas at the LP cylinder. Replace valve/hose/regulator
before continuing use.
Gas leaking from LP
cylinder
Gas leaking from LP
cylinder valve
Gas leaking between
LP cylinder and regu-
lator connection.
Fire coming through
control panel
Grease fire or exces-
sive flames above
cooking surface.
Improper installation, connec-
tion not tight, failure of seal
on LP cylinder valve.
Turn off LP Cylinder valve. Re-install correctly or tighten cou-
pling nut. Replace cylinder if seal is damaged. See “Leak Test”
and “Connecting Regulator to LP Cylinder” sections.
Flashback....
(fire in or around ven-
turi tubes.
Clogged or blocked venturi
tube.
If you can safely reach the control panel, turn control knobs to
“OFF” then close LP cylinder valve. Clean burner and venturi
tubes.“See “How To Clean Burners” Section.