Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
5
FIGURE 5
FIGURE 7
FIGURE 6
FIGURE 4
5/16" NYLOCK
NUT
5/16" x 3/4"
TRUSS HEAD
BOLT
LATCH LOCK
LEVER
COTTER PIN
WHEEL
FLAT
WASHER
FLAT
WASHER
AXLE
SPACER
TUBE
AXLE
DRAW BAR
TONGUE
LATCH STAND
BRACKET
1/4" FLAT
WASHER
1/4" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
LATCH STAND
BRACKET
LATCH
STAND PLATE
TAB
Place the drawbar tongue onto the axle and latch 7.
stand bracket then slide the axle through the wheel
support and drawbar tongue. See figure 4.
Assemble a spacer tube, a 1" flat washer, a wheel 8.
(valve stem facing out) and another 1" flat washer
onto the axle as shown in figure 5. Insert a cotter pin
through the axle, spreading the ends. Fill wheel hub
with grease. Repeat on other end of axle.
IMPORTANT: Pump grease into grease ttings until it is
forced out through ends of wheel hub.
Assemble the latch stand plate and the latch stand 9.
bracket to the bottom of the poly tray using four 1/4" x
3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts.
The aligning tab on the bottom of the latch stand
bracket must be towards the rear of the cart. Tighten.
See figure 6.
Place the poly tray down onto the wheel support, 10.
positioning it so that the latch stand bracket snaps
under the latch lock lever. Fasten the tray to the wheel
support using eight 5/16" x 3/4" truss head bolts and
5/16" nylock nuts as shown in figure 7. Tighten.