Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Validation For the most recent validation cycle, displays the Nominal Value,
Allowed Percent Deviation, and the Measured Value of each variable in
the Validation Data table. See Figure 5-5 for an example report.
Note
If the actual deviation is beyond the allowed amount, then the row will be
flagged with an asterisk (*).
Final
Validation
For the most recent validation run, shows the Nominal Value, Allowed
Percent Deviation, and the Average Value of each variable in the
Validation Data table. See Figure 5-6 for an example report.
Note
If the actual deviation is beyond the allowed amount, then the row will be
flagged with an asterisk (*).
Raw Data Displays a list of data for each peak that was detected during the run,
including the retention time, peak area, and peak height. See Figure 5-7
for an example report.
Every Run Displays a configurable list of calculations after each run. See
Section 4.5.2 for more information.
Hourly Displays a configurable list of average calculations each hour, beginning
at the time set in the Average Calculations window at Application →
Calculations → Averages... . See Section 4.5.2 for more information.
24 Hour Displays a configurable list of average calculations each day, beginning
at the time set in the Average Calculations window at Application →
Calculations → Averages... . See Section 4.5.2 for more information.
Weekly Displays a configurable list of average calculations each week, beginning
on the day set in the Average Calculations window at Application →
Calculations → Averages... . See Section 4.5.2 for more information.
Monthly Displays a configurable list of average calculations each month,
beginning on the day of the month set in the Average Calculations
window at Application → Calculations → Averages... . See Section 4.5.2
for more information.
Variable Displays a configurable list of average calculations every hour at the
time entered in the Hours column in the Average Calculations window at
Application → Calculations → Averages... . See Section 4.5.2 for more
information.
Auto Valve
Timing
Displays a Auto valve Timing report.
Module
Validation
Displays a Module Validation report.
Each report begins with the following header information:
Date-Time The GC’s date and time when the report was generated.
Logs and reports
5
Logs and reports
119