Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Fig 20
Fig 21
Fig 22
Fig 23
Fig 24
Brass Flare
Fitting
Brass Flare
Fitting
Natural Gas Conversion Instructions
Installing the NG regulator
1. Remove the hose from the brass flare fitting
using an adjustable wrench. Located inside the
cart on bottom of grill head (Fig. 20).
Remaining hose end still connected will be
removed later.
2. Remove the brass flare fitting from the gas pipe
(Fig. 21).
Note: For the following steps, the supplied pipe
sealant needs to be applied to all pipe
threads before the fittings are attached.
Pipe sealant should not be used on any
flared fittings!
3. Remove the grommet in the side of the cart by
pressing in on the side with your fingers (Fig. 22).
4. Attach the tee fitting to the gas pipe as shown.
Make sure to apply pipe sealant before attaching
fitting. Tighten with wrench (Fig. 23).
5. Attach the 3/8" MNPT to flared 90° elbow to the
tee fitting as shown. Remember to apply pipe
sealant to the pipe threads.
Tighten with wrench (Fig. 24).
7