Coleman 8100 Series Gas Grill User Manual


  Open as PDF
of 16
 
Fig 15
Fig 17
Fig 18
Fig 19
Burners fully
over valves
Rear Heat Shield
Control Knob
Stems
Fig 16
Manifold
Natural Gas Conversion Instructions
16. Start by placing the new manifold into the grill
body with the control knob stems going outward
through control panel front (Fig. 15).
17. Reattach the bezels to the manifold with the two
screws. Make sure that "off" is facing up on the
bezel. (Fig. 12 & 13).
18. Reattach the flexline on the right of the grill to
the new manifold using the adjustable wrench
(See Fig. 9 on previous page).
19. Reattach the flexline on the left of the grill to the
back infrared valve using an adjustable wrench
(Fig. 16).
20. Reattach the control knobs onto the manifold
stems, making sure the arrow is facing upwards
(See Fig. 11 on previous page).
21. Reinstall burners into the grill body. Line up the
burners with the valves on the manifold, making
sure they are level (Fig. 17 & 18).
22. Reattach the electrode and their heat shields to
the burners (Fig. 2, 3, and 4).
23. Reattach the rear heat shield before attaching
the front heat shield to be sure the burners
remain over the valves (Fig. 19).
24. Reinstall the front heat shield (Fig. 5, 6, and 7).
25. Reinstall the heat tents (Fig. 1).
26. Reinstall the cooking grates.
6
Valves
Burners
 previous next