Coleman 8100 Series Gas Grill User Manual


 
Natural Gas Conversion Kit
IMPORTANT
Read this document carefully before attempting installation
of this conversion kit. These instructions should be left with
the consumer for future reference.
For the following Coleman® Gas Barbecue Grills:
8100 Series (M/N 9992-643)
8200 Series (M/N 9992-644)
WARNING
• This Natural Gas conversion Kit must be installed only by a qualified
service technician.
• Gas supply system must be installed in accordance with the U.S.
National Fuel Gas Code.
• This appliance and its individual shut off valve must be disconnected
from the gas supply piping system during any system pressure test in
excess of 1/2 PSI (3.5 KPA).
• Use a system manual shut off valve to shut off the gas supply to this
gas appliance before continuing with installation procedures.
WARNING
• If the information in this document is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss
of life. Read the Coleman®
Gas Barbecue Use, Care & Assembly
Manual With Grill Lighting Instructions,
before attempting installation
of this conversion kit.
WARNING
• TURN OFF THE GAS SUPPLY!
DO NOT attempt to install this Natural Gas Conversion Kit
while the barbecue is in operation or is hot.
Installation and provision for combustion and ventilation air
must conform with the
National Fuel Gas Code, ANSI Z223.1
,
or
CAN/CGA-B149.1, Natural Gas Installation Code
, or
CAN/CGA-B149.2, Propane Installation Code
.
WARNING
A liquid propane tank, not connected for use with this gas barbecue,
shall not be stored in the vicinity of this or any other appliance.
Note: These instructions apply to
more than one model grill. The
parts included are designed for
your specific grill. The
illustrations may differ slightly
from model to model.
Turn off LP tank and disconnect
regulator from tank prior to servicing grill.
Connections must comply with local requirements and are the sole responsibility of the person performing
the work. A certified plumber must make connection to gas source. All codes must be followed.