Char-Broil 10601610 Electric Grill User Manual


 
8
ASSEMBLY GUIDE
GRILL FINAL Assembly
Part Qty.
C4
Controller
1
Step 1 - Install the Controller (C4) into the receptacle. Be sure to route the controller cord behind the towel bar when
installing the controller. The control knob should be facing up as you engage the tip of the controller into the receptacle.
Congratulations! You have successfully completed the
assembly of your grill.
NOTE: Be sure to press the controller into the receptacle as far as it will go. Route the
controller cord BEHIND the towel bar as shown.
C4
Receptacle
Controller
Controller Tip
Towel Bar
Ground Fault Interrupter
? Since 1971 the National Electric Code (NEC) has
required Ground Fault Interrupter devices on all
outdoor circuits.
?If your residence was built before 1971, check with a
qualified electrician to determine if a Ground Fault
Interrupter protector exists.
?Do not use this appliance if the circuit does not
have GFI protection.
?Do not plug this appliance into an indoor circuit.
Fasteners
(qty 2)
Fiber Washer
10-24x3/8"
(qty 2)
screw
Fiber
Washer
(2 each)
C5
10-24x3/8"
Screws
(2 each)
Step 2 - Install the Lid Handle with 2 10-24x3/8" screws and 2 fiber washers as shown.
C5
Lid Handle
1
Visit www.sizzleonthegrill.com/user-forums to chat with Patio Bistro® owners just like you!